 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| High Surge Current SIDACtor Device High Surge Current SIDACtor Device 1 (T) 3 (R) 2 (G) This SIDACtor device is a 1000 A solid state protection device offered in a TO-220 package. It protects equipment located in the severe surge environment of Community Antenna TV (CATV) applications. This device can replace the gas tubes traditionally used for station protection because SIDACtor devices have much tighter voltage tolerances. Electrical Parameters Part Number * P6002AD VDRM Volts 550 VS Volts 700 VT Volts 5.5 IDRM Amps 5 IS mAmps 800 IT Amps 2.2 IH mAmps 50 CO pF Pins 1-3 60 * For surge ratings, see table below. Electrical Parameters Part Number * P3100AD VDRM Volts 280 VS Volts 360 VT Volts 5.5 IDRM Amps 5 IS mAmps 800 IT Amps 2.2 IH mAmps 120 CO pF Pins 1-3 115 * For surge ratings, see table below. General Notes: * All measurements are made at an ambient temperature of 25 C. IPP applies to -40 C through +85 C temperature range. * IPP is a repetitive surge rating and is guaranteed for the life of the product. * Listed SIDACtor devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities. * VDRM is measured at IDRM. * VS is measured at 100 V/s. * Special voltage (VS and VDRM) and holding current (IH) requirements are available upon request. * Off-state capacitance (CO) is measured at 1 MHz with a 2 V bias and is a typical value. Surge Ratings IPP 8x20 s Amps 1000 IPP 10x1000 s Amps 250 ITSM 60 Hz Amps 120 di/dt Amps/s 500 Series D http://www.littelfuse.com +1 972-580-7777 2 - 60 (c) 2004 Littelfuse, Inc. SIDACtor(R) Data Book and Design Guide High Surge Current SIDACtor Device Thermal Considerations Package Modified TO-220 Symbol TJ TS RJA Parameter Operating Junction Temperature Range Storage Temperature Range Thermal Resistance: Junction to Ambient Value -40 to +150 -65 to +150 60 Unit C C C/W PIN 1 PIN 2 PIN 3 Note: P6002AD is shown. P3100AD has no center lead. +I IPP - Peak Pulse Current - %IPP tr = rise time to peak value td = decay time to half value IT IS IH IDRM -V VT VDRM VS +V 100 Peak Value Waveform = tr x td 50 Half Value 0 0 tr td t - Time (s) -I V-I Characteristics tr x td Pulse Wave-form 14 Percent of VS Change - % 12 8 6 4 2 0 -4 -6 -8 -40 -20 0 20 40 60 80 100 120 140 160 IH IH (TC = 25 C) 10 2.0 1.8 1.6 1.4 1.2 1.0 0.8 0.6 0.4 -40 -20 0 20 40 60 80 100 120 140 160 25 C 25 C Ratio of Case Temperature (TC) - C Junction Temperature (TJ) - C Normalized VS Change versus Junction Temperature Normalized DC Holding Current versus Case Temperature (c) 2004 Littelfuse, Inc. SIDACtor(R) Data Book and Design Guide 2 - 61 http://www.littelfuse.com +1 972-580-7777 Data Sheets |
Price & Availability of P6002AD
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |